http://www.commodore.ca/manuals/c64_pro ... _guide.pdf
An attempt was made to communicate with the serial port to a device operating at 9600 baud
it was my belief that initiation would be facilitated with
Code: Select all
OPEN 1,2,0, CHR$(140)
attempts were then made to send data
Code: Select all
PRINT#1, A$
Code: Select all
GET#1, B$
?ILLEGAL DIRECT ERROR
I might be far off base with the code, but the settings for vice complicate the matter
serial interface is /dev/ttyUSB0
for RS232 settings do I use user port emulation, can it support (140) even though the book says its Non imp.
or should I be using ACIA
has anyone had success communicating via rs232 in Vice in any of there configurations